Description
HVAC Blower Motor Assembly 700202 79220-SHJ-A01 79220-SHJ-A02 87103-42060 Heater Blower Motor with Fan Cage Fit for 2005-2010 Honda Odyssey; 2005-2009 Subaru Legacy Outback; 2004-2005 Toyota RAV4 ★★ FITMENT: Fit for 2005-2010 Honda Odyssey 3.5L, Fit for 2008-2009 Subaru Legacy 2.0L, Fit for 2005-2009 Subaru Legacy 2.5L, Fit for 2008-2009 Subaru Legacy 3.0L, Fit for 2005-2009 Subaru Outback 2.5L, Fit for v2005-2009 Subaru Outback 3.0L, Fit for 2004-2005 Toyota RAV4 2.4L ★★ REPLACE: 700202, 79220-SHJ-A01, 79220-SHJ-A02, 87103-42060, PM9314 ★★ FUNCTION: HVAC Blower Motor with Fan is responsible for producing air that goes through the vents of your vehicle's AC and heating system. If your AC or Heater does not produce or circulate any heated or cooled air then you may have a problem with your blower motor. ★★ HIGH QUALITY: Every Blower Motor must take inspected and tested multiple times before the shipment,Our Blower Motor Model with strong heat dissipation,reduce the rate of burning electronic parts. FITMENT: Fit for 2005-2010 Honda Odyssey 3.5L Fit for 2008-2009 Legacy 2.0L Fit for 2005-2009 Legacy 2.5L Fit for 2008-2009 Legacy 3.0L Fit for 2005-2009 Outback 2.5L Fit for 2005-2009 Outback 3.0L Fit for 2004-2005 Toyota RAV4 2.4L Replaces Part Numbers: 700202 79220-SHJ-A01 79220-SHJ-A02 87103-42060 PM9314 How to replace with new HVAC blower motor? 1 Always wear eye protection and start with installation tools. 2 Locate the HVAC blower motor under the passenger side dash. Removing the dash may be necessary to access the blower motor on some vehicles. (Note: On older vehicles, the blower motor may be located in the engine compartment on the passenger side firewall.) 3 Disconnect the blower motor electrical connector. 4 Remove the retaining screws to the blower motor assembly. 5 Remove the box and blower motor assembly. 6 Remove the blower motor retaining screws. Remove the motor from the box. 7 Compare the new blower motor to the old one to verify that you have the correct part. Install the new motor into the box and tighten the retaining screws. Re-install the blower motor assembly. 8 Connect the blower motor electrical connector. 9 Operate the heating and A/C system. Verify that the blower motor operates at all speeds and that the system produces hot and cold air.